3/8″ PUSH ON X 1/4″ FEMALE NPT

#F-3.2.052

Push on Hose Barb x Female NPTF. Push-on fittings are intended for use with Lok-On (push-on style) hose only. No hose clamps or ferrules are needed

Caution: Push-on fittings will properly grip push-on hose only when pushed all the way in, with the cut end of the hose completely concealed by the plastic cap.

1. Trim hose end with smooth square cut.
2. Lubricate either push-on fitting, hose or both.
3. Insert push-on fitting into hose until first barb is in hose.
4. Place end of fitting against a flat object (bench, wall, etc.) and grip the hose one inch from end. Push with a steady force until end of hose is covered by yellow plastic cap.

1. Leaving push-on fitting in place, make a 1″ cut in the hose along the barbed end of the fitting. Note: Be careful not to nick barbs when cutting the hose.
2. With firm grip on hose, give a sharp downward pull to release the fitting from the hose.

Product Features
Material: Brass
Weight: 0.055 lb
Component Material: Yellow Plastic Cap
Female Thread: NPTF
Length: 1.66″
Hose ID: 3/8″
Hex: 5/8″
Female Thread Size: 1/4″
Pressure Rating: 350 PSI
Temperature Range: -40F to 150F (-40C to 65.6C)
Number of Barbs: 2
Barb Length: .92″
Product Number: BPF32

General Applications
Push-on hose fittings, used to attach connectors and fittings to hoses for low-pressure hydraulic and pneumatic systems such as shop air, general industrial, maintenance and automotive assembly, to name a few. The assemblies handle pressures up to 350 psi, a limit set by the hose’s capabilities. Push-on fittings are intended for use with Lok-On (push-on style) hose only.